The scope of this project was to increase the effectiveness of their system for exhausting styrene fumes. This was to be accomplished by:
 |
Creating a duct hood system that better captured the fumes at the presses where the fumes were
generated. |
|
Installing a new blower to increase the exhaust CFM from 42,000 to 60,000. |
|
Installing a 55,000 CFM make up air system to control the flow of fumes generated outside of the presses and direct them to the low exhaust ports. |
|
Making the system air balanced. |
The interior photos are of the drops we made to (44) presses. Each tool had an exhaust connections on the top of the machine and a low exhaust port to capture fumes created outside of the presses. We modified the exhaust trunk line on the roof and then installed a complete new make up air system.
|
